1995 SBC STROKER S10.

1995 GMC Sonoma

This truck was bought after it's previous owner had hit a deer and had done some major damage to the front end as well as heat seizing the 4.3l V6. The body was repaired and then block sanded many times to give it a strait clean look. A custom steel welded roll pan and tailgate were added and it was painted in Cadillac sunset orange pearl paint. The 4.3l was then re-built and givin a new life, that's not where the story ends however after a couple of years a new motor was built to replace the 4.3L and here it is;

-SBC 350 4-bolt main roller motor borred 40 over.

-Hyperutectic pistons

-Comp hydrolic roller cam shaft.

-Edlebrock air gap manifold.

-holley 750 cfm carb.

-Rebuilt ported and polished 202I,160E, 292 angle plug iron heads.

-Built 700R4 trans with 2500 stall converter and a shift kit.

-7-5/8 factory posi.

A few other subtle however unique things were done to this truck including a custom hand made console designed to look factory but housing a B&M Hammer shifter. Another add-on was the ZQ8 Quick ratio steering package, sway bars and the wheels to go with, almost as if this was a GM option. Finally M/T 255/50/16 drag radials were put on to get this truck to hook up.